The figure of the hood appears in every household and is an essential item in life. The role of sanitation and cleanliness and the range hood is also inseparable. The performance of the range hood is inseparable from the correct installation and maintenance . The appearance of the hood can make a huge change in the kitchen, but after a period of use , the hood needs professional cleaning. Xiaojia of the home network will introduce you: the skill of cleaning the small hood .
First, the hair dryer heating method uses the hot air of the hair dryer to blow the oil for about 20 seconds. Then use a scouring pad to apply a little bit of detergent and wipe the greasy area. After the oil was blown by the hot air of the hair dryer, it became a lot softer. Blow a part, rub a part, and wipe off the oil easily. I want to blow where I want to blow, and even the corners of the corners and the gullies can be blown, and of course I can wipe them clean.
Second, the Plastic Bottle spraying method, take a plastic bottle (a variety of beverage bottles that can be pinched by hand), poke more than 10 small holes in the cover with a sewing needle, and then, put the right amount of cleaning essence, and then Fill with warm water and shake evenly. Start the range hood, use a plastic bottle filled with cleaning essence to spray the cleaning liquid toward the part to be washed. At this time, it can be seen that the oil and dirty water flow into the oil storage hopper together with the overflow. After the cleaning solution in the bottle is used up, continue to prepare and repeat the cleaning. Until the dirty water that flows out becomes clear, depending on the degree of fouling, it can be washed clean after 3 times of cleaning. If a fan cover is installed outside the fan blade, the mesh cover is first taken down to enhance the washing effect. Use a rag to clean the area around the suction port, the surface of the case, and the lamp cover.
Third, use the residual temperature to easily scrub the method, take advantage of the residual heat on the range hood, wipe the surface slightly with a rag, you can easily wipe the oil stains on the range hood, often clean and not greasy.
4. The oil storage box is free of washing method. A layer of plastic wrap is attached to the box. The plastic wrap must be partially outside the oil storage box to completely cover the inner surface of the original box, so that the soot is adsorbed on the cling film. You can pick up the replacement for a while. Or use the finished plastic pudding cup or paper cup instead of the original oil storage box, as long as the regular replacement can save the trouble of cleaning and not easy to wash.
Small hood installation method
1. The top suction hood takes into account the convenience of operation and the smoking effect, and the height from the cooktop is generally between 65-75 cm; while the bottom suction hood is closer to the cooktop, generally between 35-45 cm. . The top suction and side suction hoods should be installed horizontally above the cooker, and the vertical center axis of the hood should overlap the cooker line.
2, the range hood should be installed in the gas cooker point directly above the position, try not to install the range hood in the door and window and other places where the air convection is strong, so as not to affect the effect of the oil smoke. The outlet pipe should not be too long, it should not exceed 2 meters, and try to reduce the bend and avoid multiple 90 degree bends, otherwise it will affect the effect of oil smoke.
3. The hood should pay attention to the level of the body during the installation process. After installation, observe the level and avoid tilting. Make sure the hood is not shaken or unhooked. If the smoke is exhausted to the shared flue, do not insert the exhaust pipe too deep to increase the exhaust resistance. If it is open to the outside, be sure to extend the exhaust nozzle by 3cm.
4. There are several main steps in installing a range hood. First, check whether the equipment is complete before installation and then determine the installation location, then fix the hood of the hood and hang the hood on the hang plate; at the end, install the exhaust pipe, install the oil cup, and adjust the hood. Although the steps are relatively simple, every detail must be taken care of.
Since the appearance of the range hood, it has been widely praised by people. It has created a better housing environment for people, but after a period of use, the knowledge of the maintenance of the range hood is not widespread. Many users often feel overwhelmed when cleaning small hoods. I don't know how to clean the hood. If you want to know more information, please continue to pay attention to the decoration home network.
More related wonderful reading:
What are the sizes of range hoods? How to choose the size of the range hood?
How to install a household hood? Household hood installation process
How to choose a household hood? What are the classifications of household hoods?
How to choose a range hood? Range hood purchase strategy
How to determine the installation position of the range hood? How to install the range hood?
Glass Bottle,Glass Double Wall Bottle,Glass Tea Bottle,Glass Bottle With Silicone Cover
Ningbo Auland International Co.,Ltd. , https://www.everwaterbottle.com