With the continuous improvement of the times, many friends have a higher pursuit of lighting demand, and the speed of lighting replacement just coincides with the pace of people's life development. Today, inductive foot lights are used more and more in many homes. But the question is, is the induction foot light wired ? How to route it? The following small series will give you answers to these two questions!
First, the use of induction foot lights
When the human body walks within the detection range of the inductive footlight, it automatically lights up when it detects the movement of the human body, and goes out after a delay. If the human movement is detected again during the delay, the delay time will be recalculated. It should be noted that after the induction foot light is turned on, it takes 50 seconds of warm-up time to enter the normal working state.
Second, the induction foot light should be wired?
In fact, the induction foot lights are all wired. At the beginning of the wiring, the position of the foot light can be reserved and installed. The induction foot light does not need to be controlled by the switch, it can be directly connected to the power supply, and then it will work automatically according to the environment and function. Under normal circumstances, you can reserve the zero line and the fire line. Because it has the sensing function, it can realize the normal function without the switch.
Third, how to inductive foot light wiring
Install the bottom box on the wall, pay attention to the mounting direction of the screw position. The correct method for installing the foot light is to fix the screw hole vertically downward. Then pull the cover off the lamp body, taking care not to damage the lamp body and appearance. After connecting the wires, put the lamp body into the bottom box, tighten the screws, and cover the top cover.
Fourth, the characteristics of the induction foot light
1, low power consumption
Smaller in size and lower in power consumption, it is convenient in both wiring and use. In addition, it is also resistant to leakage and water, and there is no need to replace the bulb without special circumstances.
2, good security
Inductive foot lights can be automatically sensed according to the position of the human body, avoiding the shackles of the lamps that can be found at night, or because the light is too bright to affect other people's rest.
3, practical
Induction foot light is often used in the aisle, it can drive the surrounding light and human body induction, and the light source adopts LED environmental protection light source, low heat and no stroboscopic, radiation, no filament light, easy to burn, etc., long service life .
The above is about the wiring of the induction foot light, I hope to help everyone! Qi installed network, China's well-known large-scale decoration platform, decoration leading brand. If you want to make a new design, you are advised to apply for the free design service of the net, and help you plan a reasonable space layout and beautiful design through the professional designer's on-site measurement room.
>> Click here for professional designer free room design
Spring Mattress,Twin Gel Memory Foam Mattress,Hybrid Mattresses,Memory Foam Spring Mattress
Foshan Aussie Hcl Furniture Co., Ltd. , https://www.hclexport.com